Took apart the right side handlebar by sliding everything off. A bit of compressed air under the grip helped. After that slid everything back on starting with the accelerator.
I marked the bar for where the brakes and gear shifter were originally mounted. That way the cable lengths didn't need to be adjusted and the stock grip fit back on correctly. I decided to not change out the brake handles at this time. The ones from the kit have shut off's built into them. Since I am not using the PAS system at this time, I don't see the need for this. I will just let off the accelerator when I engage the brakes to stop. I can always install later if needed.
I also connected everything and did a test. Everything worked as expected!
I next modified a few of the settings in the display. Changed the ODO from KM to Miles. Also changed the default power mode to accelerator only from combo PAS/accelerator.
No comments:
Post a Comment